Monitoring of Volcán de Colima

Version española Versión española


Monitoring of an active volcano is currently undergoing a revolution with many new methods being introduced to aid in the prediction of eruptive activity. Remote sensing has greatly improved our capability, particularly for more remotely located volcanoes. Different monitoring techniques can be characterised by the frequency that data is obtained. This can vary from between monthly for spring data to 100 samples per second in the case of seismicity.

It is important not to forget the most basic form of monitoring which is pure observation. Information such as variation in the size of the volcanic plume, a change of colour, the height of an eruption column, formation of new fumaroles, change in the size of a crater lake etc. can provide critical information for hazard assessment.

Historically the main methods could be divided into the following:

a) Seismic

At many volcanoes this represents the principal method of 'reading' the behaviour of the volcano. Even with a small network it is often possible to observe seismicity related to the rising magma body prior to an eruption.

b) Geodesic

When magma pushes its way up from beneath a volcano there is usually associated movement of the volcanic edifice. This can be recorded by using GPS equipment, EDM (Electronic Distance Measurement), Levelling or Tilt meters. Satellite-based sensors can also be used to identify and expanded edifice (INSAR).

c) Geochemical

This area of monitoring looks at the interaction between fluids and gases originating from a volcano and the surface or near sub-surface environment. Also the geochemistry of solid products can provide vital information in the analysis of the state of activity. The following measurements are commonly carried out: the flux of gas released by the volcano; its composition; geochemistry of the discharge in local spring waters; flux of gas diffusing though the ground; characteristics of ash produced by explosions; geochemistry of samples from domes or lava flows. Various satellite-based sensors have been used to detect both the SO2 and ash content of volcanic plumes.

Plume gas composition
When the volcano does not have explosive activity it is possible to climb to the crater and take samples directly from the fumaroles. This is the ideal way to analyse the composition of the volcanic gases. Samples are taken in special sampling bottles and are later analysed in the laboratory. Concentrations of the major gas species can be obtained (CO2, SO2, HCl, N, He, Ar, etc.), also isotopic analyses are usually carried out of the water isotopes.

It is planned to install diffusion tubes near to the summit as an alternative method for analyzing the major gases.

Juan Carlos sampling fumaroles

Ash studies
Volcanic ash is a term given to small particles (less than 2 mm in diameter) of rock, minerals and volcanic glass that are expelled from a volcano during an explosive eruption... see more

The other less commonly used techniques can be divided as follows:

  • Geophysical
    • Self-potential
    • Microgravity
    • Electromagnetic
    • Geomagnetic
    • Doppler radar
  • Thermal
    • Satellite-based sensors
    • Infrared cameras and other ground-based sensors
    • Direct fumarole temperature measurement
  • Infrasound

Volcán de Colima

Monitoring of Volcán de Colima is carried out by members of the Volcanological Observatory and the Committee for the Evaluation of Risk of the Universidad de Colima. At the Centre of Exchange and Research in Volcanology we are responsible for geochemical, thermal and infrasound monitoring.

Information on seismic and deformation monitoring can be found on the Observatory website along with images from the cameras being installed at various points close to the volcano.

1) Geochemical monitoring at Volcán de Colima can be divided into the following areas:

  • Flux of SO 2
  • Monitoring of spring waters
  • Diffuse gases
  • Plume gas composition
  • Geochemistry of lava
  • Ash studies

This area of monitoring has proved very useful at Volcán de Colima. There have been some effusive periods that have not given any signal in the seismicity but did produce geochemical anomalies prior to their onset (2001-3).

In this area of monitoring we also include thermal monitoring. This can be carried out using satellite-based sensors which give a low resolution but a guaranteed daily measurement if the skies are free of clouds. CUICA has receivers for data from two types of sensor: AVHRR and GOES. Recently ground-based monitoring has been introduced at Volcán de Colima.

2) Thermal monitoring

3) Infrasound


Plume to South 20th September 2002

Volcanic plume towards the south, 20th of September 2002.


Colima Exchange and
Research in Volcanology
Faculty of Science
University of Colima

Bernal Díaz del Castillo #340
Col. Villas San Sebastián, C.P. 28045
Colima, Colima, México

  • +52 (312) 316-1000 ext. 48002
  • 316-1135 (Faculty Secretary)
since 01/10/2005

Author: Dr. Nick Varley
Design: Till Sonnemann, Carlos Banda and Luis Banda
Updating: Adrián González, Eduardo Velasco
Last Changes: 24th-January-2015
URL of this page: www.ucol.mx/ciiv

©COPYRIGHT - all photos on this website are owned by the authors and permission must be sought for their use in any form.